Products

Applicable Fibers Single-mode (G.652 & G.657), Multimode (G.651), DS (G.653), NZDS (G.655)

Cladding Diameter 80μm to150μm

Coating Diameter 100μm to 1,000μm

Fiber Cleave Length 8 to 16mm with 250μm coating diameter, 16mm with 900μm coating diameter

Typical Average Splice Loss 0.02dB with SM, 0.01dB with MM, 0.04dB with DS, 0.04dB with NZDS, measured by cut-back method relevant to ITU-T and IEC standards

Splicing Time Typical 9 seconds with standard single-mode fiber

Arc Calibration Method Automatic, real-time and by using results of previous splice when in AUTO mode, manual arc calibration function available

Splicing Modes 100 preset and user programmable modes

Splice Loss Estimate Based upon dual camera core alignment data

Storage of Splice Result Last 2000 results to be stored in the internal memory

Fiber Display X or Y, or both X and Y simultaneously. Front or rear monitor display options with automated image orientation

Magnification 300X for single X or Y view, or 187X for X and Y view

Viewing Method Dual cameras with 4.1 inch TFT color LCD monitor

Operating Condition 0 to 5,000m above sea level, 0 to 95%RH and -10 to 50°C respectively

Mechanical Proof Test 1.96 to 2.25N

Tube Heater Built-in tube heater with 30 heating modes; auto-start function

Tube Heating Time Typical 30 seconds with FP-03 sleeve, 35 seconds with FP3 (40), 35-55 seconds with Fujikura micro sleeves

Protection Sleeve Length 60mm, 40mm, micro

Splice/Heat Cycles with Battery Typical 160 cycles with power save functions activated

Power Supply Auto voltage selection from 100 to 240V AC or 10 to 15V DC with ADC-11, 13.2V DC with BTR-08 battery

Terminals USB 1.1 (USB-B type) for PC communication. Mini-DIN (6-pin) for HJS-02/03 and SH-8 tube heater

Wind Protection Maximum wind velocity of 15m/s. (34 mph)

Dimensions 136W x 161D x 143H (mm) / 5.3W x 6.3D x 5.6H (inches)

Weight 2.3 kg (5.1 lbs) with AC adapter ADC-11; 2.7kg (5.9 lbs) with BTR-08 battery